Included: one 3-in-1 Dial Tool (Made of aluminum, 4 thumb screws with hex style head) configured with dial feet template holes for the ETA 2824-2, Seiko NH35A, and ETA 6498-2 movements dial foot locations and all movements sharing these same outfit configurations.

This tool provides clamping, alignment, heat sink, and serves as a dial template tool. It will accommodate dial blanks with preinstalled dial feet and also dial blanks without feet.

The opening on the clamping plate for this tool is about 39mm (other opening sizes available upon request). Clamp plate openings will slightly vary within 0 to to .05cm larger, however, if you need a precise size within .01cm please contact me for pricing and sizes available as I would need to use specialized tooling to achieve a specific tolerance.

The finished tool size is just under 50mm x 60mm (within a few millimeters) to the finished size. I precision locate with a laser measuring device and then hand drill the dial feet positions with a pin vise for the template dial foot hole positions. I test fit a blank dial in each tool I make to ensure it sure it is absolutely accurate.

Please allow up to 5 business days for production to make your tool before shipment.

These tools are made one at a time and one should expect slight variations in size, appearance, and finish due to the handcrafted process.

I offer a 90 day limited warranty for manufacture defects. It is not warranted for any specific use or function and wear and tear, including any physical alterations or damage to the tool are not covered. This tool is custom made when it is ordered and no returns are accepted.